Canceling Printing - Kyocera FS-6900 User Manual

Canceling Printing

Perform the following procedure when you wish to cancel printing after it has begun.
1.
Check if the messageý3URFHVVLQJ is displayed in the message display.
2.
Press the ON LINE key to take the printer offline.
3.
Perform the necessary procedure on the computer to halt printing.
4.
Press the CANCEL key.
The messageý 3ULQWý &DQFHO" will appear in the message display and the interface
5.
to be canceled will be displayed.
The following interfaces may be displayed.
3DUDOOHO
6HULDO
2SWLRQýì (appears only when an optional interface is installed)
2SWLRQýë (appears only when an optional interface is installed)
6.
Selecting the interface to cancel using the + or – key and then press the ENTER key.
Printing from the interface selected will be stopped.
A few pages may be printed even after the CANCEL key is pressed as remaining data
received before the CANCEL key was pressed is printed.
The messageý3ULQWý&DQFHO"ý&XUUHQWýMRE will also be displayed when the
CANCEL key is pressed for the purpose of stopping the printing of status pages or font
lists from the control panel. When the ENTER key is pressed, the messageý&DQFHOð
OLQJýGDWD appears in the message display and printing stops after the printer fin-
ishes printing the current page. Cancellation affects only the print job currently in
progress; later jobs are not affected.
Press the CANCEL key again if you wish to stop the cancellation of printing.
Press the ON LINE key to put the printer back online to continue with other print jobs.
‹
Canceling data from the computer using the CANCEL key will restore temporary set-
tings to their default values. (The same status resulting from executing the PRE-
SCRIBE 2e RES command.)
‹
It is impossible to cancel printing of just one side when printing in duplex mode
using an optional duplex printing unit (DU-25).
2.2. Operating Procedures
2-9