7-Open The Paper Stopper On The Face-Down Output Tray (If Required); 8-Install The Face-Up Output Tray (Sold Separately); 9-Connect The Printer To The Computer - Kyocera FS-6900 User Manual

1.4. Setting Up and Interfacing
7—Open the Paper Stopper on the Face-down Output
Tray (if required)
Open the paper stopper as shown in the figure.
Depending on the paper, printing without
opening the paper stopper may result in
more evenly aligned output. Decide
whether or not to use the paper stopper
after checking the output condition of
paper.
8—Install the Face-up Output Tray (sold separately)
Use the separately sold PT-3 face-up output tray
if you want the printed pages stacked face-up
(reverse order). Install the face-up output tray
as shown in the figure.
9—Connect the Printer to the Computer
The printer has two computer cable connectors and a slot for installing an option interface.
The one marked "
"IOIOI" is for a serial (RS-232C/RS-422A) interface. You may use whichever is convenient
for your computer, with the option interface, if you have already have one installed. All
interface connectors can be used simultaneously with different computers.
Option Interface/Hard Disk
Unit Slot Cover (OPT2)
Parallel Interface Connector ( )
Only connect or disconnect cables to the connectors while the printer and computer
power are switched off.
1-16
" is for a parallel (Centronics standard) interface. The one marked
Serial Interface (RS-232C/RS-422A)
Connector (IOIOI)
Paper Stopper
Face-up Output Tray (PT-3)
Option Interface Slot
Cover (OPT1)