Basic Printing Operations; Selecting The Output Tray - Kyocera FS-6900 User Manual

Basic Printing Operations

The flow of basic operations to print is given below. Keys on the control panel are explained
after that. For details on using the MODE key, be sure to read the section "Mode Select Menu"
at the end of this manual in conjunction with this section.
1.
Use the MODE key to set an emulation for the printer which conforms to the software
being used.
This printer is shipped from the factory with emulation set to PCL 6.
2.
Use the MODE key to select the font to use and paper direction.
3.
Use the FEED key to select paper feeding from the cassette or the MP tray.
4.
Use the STACK key to select the destination output tray.
5.
Use the MODE key to set the number of printed copies.
Check that the messageý 5HDG\ appears in the message display and that the ON LINE
6.
indicator lights, then make preparations to print from the computer.
Press the FORM FEED key if, after printing, the messageý:DLWLQJ appears in the message
display.

Selecting the Output Tray

Printed paper can be output on either the face-up output tray or the face-down output tray.
Selecting the face-up output tray will cause paper to be stacked with the printed surface fac-
ing up. Selecting the face-down output tray will cause paper to be stacked with the printed
surface facing down. Normally it is more convenient to use the face-down output tray.
The optional PT-3 face-up tray must be installed in the printer to output pages face-up tray.
When the messageý5HDG\ orý$GGýSDSHU appears in the message display, the output
tray will be switched every time the STACK key is pressed and the selected destination will
appear in the message display as follows.
)DFHðXSýWUD\
)DFHðGRZQýWUD\
The output tray currently selected will also flash
on the indicator on the front panel.
Face-Down Tray Indicator
Face-up Tray Indicator
2.2. Operating Procedures
2-7