Ethernet - Proxim ORiNOCO AP-4900M User Manual

Advanced Configuration
Interfaces
6. Select which encryption method to use (if any) from the WDS Security Mode drop-down menu.
7. If you selected a WDS Security Mode, do one of the following:
• If you selected WEP: Enter an encryption key.
• If you selected AES: Enter a shared secret.
8. Enter the MAC Address that you wrote down in Step 2 in one of the Partner MAC Address field of the Wireless
Distribution Setup window.
9. Set the Status of the device to Enable.
10.Click OK
.
11. Reboot the AP.

Ethernet

Select the desired speed and transmission mode from the drop-down menu. Half-duplex means that only one side can
transmit at a time and full-duplex allows both sides to transmit. When set to auto-duplex, the AP negotiates with its switch
or hub to automatically select the highest throughput option supported by both sides.
Figure 4-17 Ethernet Sub-tab
For best results, Proxim recommends that you configure the Ethernet setting to match the speed and transmission mode
of the device the Access Point is connected to (such as a hub or switch). If in doubt, leave this setting at its default,
auto-speed-auto-duplex. Choose between:
• 10 Mbit/s - half duplex or full duplex
• 100 Mbit/s - half duplex or full duplex
• Auto speed - auto duplex
AP-4000/4000M/4900M User Guide
66