Proxim ORiNOCO AP-4900M User Manual page 219

Command Line Interface (CLI)
Parameter Tables
Name
Medium Occupancy
Factor
Signal Strength Cutoff
Max Hops to Portal
Mesh Mobility Mode
(Mesh AP only)
Reset Mesh Parameters
‡
to Defaults
Mesh QoS Profile
Mesh Link Only (no client
access on Mesh radio)
Mesh Auto Switch Mode
(Mesh Portal only)
Current Mesh Mode
* Higher roaming threshold value creates a more static Mesh environment. Lower roaming threshold value creates a more dynamic Mesh
environment.
† A QoS profile corresponding to this index number must exist.
‡ This command resets the following parameters to their default values: Maximum Active Mesh Links, Maximum Hops to Portal, Hop Factor,
RSSI Factor, Medium Occupancy Factor, Receive Signal Strength Cut-off, and Roaming Threshold.
Type
Integer32 0–10
Integer32 0–26
Integer32 1–4
Integer 1 (static)
2 (roaming)
Integer32 1 or 2
Integer32 1–10
Integer 1 (enable)
2 (disable)
Integer 1 (enable)
2 (disable)
Integer 1 (Disabled) (default)
2 (Mesh Portal)
3 (Mesh AP)
AP-4000/4000M/4900M User Guide
Value Access
†
CLI Parameter
RW meshmedocfactor
RW meshsignalstrengthcutoff
RW meshmaxhops
RW meshmobility
RW meshadvresettodefault
RW meshqosprofile
RW meshlinkonly
RW meshautoswitchmode
R meshcurrentmode
219