Mesh - Proxim ORiNOCO AP-4900M User Manual

Advanced Configuration
Interfaces

Mesh

Mesh functionality can be enabled on only one of the AP's wireless interfaces. When configured for Mesh, the AP's
wireless interface simultaneously functions as a Mesh link and as a radio to service clients.
CAUTION: Mesh mis-configuration may cause problems in your wireless network. Before configuring an interface for
Mesh functionality, see
NOTE: AP-4000 units must use software version 3.4 (or later) to enable mesh functionality. For information on upgrading
your unit's software, see
Basic Mesh Parameters
Figure 4-18 Basic Mesh Parameters
Configure the following basic parameters for Mesh functionality, and click OK.
NOTE: Changes to these parameters require a reboot in order to take effect.
• Mesh Mode: Use this drop down menu to enable/disable Mesh functionality on a wireless interface. When Mesh
Mode is set to Disable, all other parameters on this tab will be grayed out. To enable Mesh functionality, choose one of
the following:
– Mesh Portal: Choose this option if the AP will be connected directly to the wired backbone.
– Mesh AP: Choose this option if the AP will connect to the portal and backbone wirelessly.
NOTE: Proxim recommends enabling Auto Channel Select when configuring an AP as a Mesh AP. Auto Channel
Select is configured on the Wireless A or Wireless B page. See
Wireless-B (802.11b/g Radio)
Mesh Network Configuration.
Installing the Software.
for more information.
AP-4000/4000M/4900M User Guide
Wireless-A (802.11a/4.9 GHz Radio) and
67