Beep And Power Saver - Icom IC-W2A Instruction Manual

Lace
BEEP AND POWER SAVER 13 Ei
@ Beep tone
The transceiver emits a beep tone each time a switch is
pushed. For silent operation, the beep tone can be turned
OFF.
OPERATION
While pushing [F], push [@& BEEP] to turn OFF and ON the
beep.
NOTE
Even if the beep is OFF, the transceiver emits a beep tone
for the pager function and an optional" pocket beep function.
"Built-in to the U.S.A. version.
@ Display lighting
The display lighting has a 5 sec. timer for night operation. If
you need continuous lighting, follow this procedure:
OPERATION
To activate lighting for 5 sec.:
Push [(@) LIGHT]
To activate continuous lighting :
- While pushing [F], push [@) LIGHT].
- Push [@) LIGHT] to turn the lighting OFF.
The*continuous lighting remains activated even if the
power is turned OFF and ON again.
@ Power saver vse SET MODE
The power saver function reduces the current drain to con-
serve battery power during the standby condition. The duty
cycle of the power saver can be selected and can be turned
ON or OFF to suit your operating style.
125 msec. Power saver is
turned OFF.
Standby 125 msec.
Circuit off 500 msec, 2 sec.
1) Enter SET mode:
- Push [V MAIN] or [U MAIN] to select the desired band.
- Push [@ V/M] to select VFO mode. (''M'' disappears).
- While pushing [F], push [(@) SET] to enter SET mode.
2) Push [A/SCAN] or [V/SCAN] several times to select the
duty cycle setting display as shown above.
3) Rotate the tuning contro! to select the desired duty cycle
or to turn the function OFF.
4) Push [&) CLR] to exit SET mode.