Terminal Configuration; Data Format; End Of Message; Setting Up A Hyperterminal Connection - Xantrex 850W Operating Manual

Ethernet (ENET)

Terminal Configuration

The terminal program allows for communication with the power supply.
To use a terminal program, set it up using the parameters from the
following sections. If you wish to use HyperTerminal, see "Setting Up a
HyperTerminal Connection" for instructions.

Data Format

Serial data format is 8 bit, one stop bit. No parity bit. Flow control: none.

End of Message

The end of message is the Carriage Return character (ASCII 13,
0x0D).The power supply ignores the Line Feed (ASCII 10, 0x0A)
character.

Setting Up a HyperTerminal Connection

To set up a HyperTerminal connection:
1. Start Windows HyperTerminal by clicking Start >All Program

Figure 2-22 HyperTerminal Connection

2-18
>Accessories > Communications > HyperTerminal.
See Figure 2-22.
M370046-06