Xantrex 850W Operating Manual page 53

5. Configure the master power supply which is the unit with the ENET
6. The following Steps 7, 8 and 9 must be repeated for each slave unit.
7. For the slave unit that you are setting up, turn the 9-Position Mode
8. Turn the Rotary knob/Enter button to select SLA and press the Rotary
9. Set a unique address and press the Rotary knob/Enter button. See the
10. Set up the fixed IP address for the first unit using DeviceInstaller as
11. Create and set up a new HyperTerminal session as described in
12. In the HyperTerminal session window, type the *ADR <#>;*IDN?
13. Verify that the unit responds with the ID string. Perform this test for
14. If additional XTR units are using Network Topology 2, repeat the
Important:
but the RS-485 bus addresses can be reused for each unique ENET – RS-485
group.
M370046-06
option (power supply #1 in Figure 2-35) by following the instructions
in "Selecting ENET as the Communication Port" on page 2–17.
Control Knob to PGM.
rE is displayed in the output voltage display.
knob/Enter button.
XTR 850 Watt Series Programmable DC Power Supply Operating
Manual (Part number: M370046-01), Chapter 5, "Multichannel
Address Setting" section for a more detailed discussion of addressing.
Once all slave units have been setup, proceed with the next step.
described in "Assigning an IP Address to the Power Supply Unit" on
page 2–12.
"Terminal Configuration" on page 2–18.
command where the <#> should be replaced by the address assigned
to the power supply in step 9. Press enter to send the command.
each unit that is connected including the master unit.
setup procedure steps 1 to 14 for each ENET and RS-485 group.
The IP address for each ENET and RS-485 group must be unique,
Advanced Section
2-31