Ethernet (ENET)
Figure 2-36 HyperTerminal Window
Figure 2-36 shows the HyperTerminal session for the combined
configuration which is an ENET and RS-485 network. This figure also
shows access to power supplies #2 and #10 sequentially.
Setting Up Your System
To set up your system:
1. Connect your system as shown in Figure
2. Set up your computer as described in "Setting Up the Computer" on
3. Install the DeviceInstaller software on the PC you wish to use to
4. Configure the ENET card of the master XTR (power supply #1 in
2-30
supply unit to ON.
page 2–6. Repeat this section for each computer hooked up to the
system.
configure the XTR unit (s) with. See the instructions for "Software
Installations" on page 2–9.
Figure 2-35). See the instructions for "Configuring the Device Using
DeviceInstaller" on page 2–11.
2-35,
and turn every power
M370046-06