Troubleshooting For Enet Communication; Table A-2 Troubleshooting For Enet Communication - Xantrex 850W Operating Manual

Troubleshooting for ENET Communication

This section describes typical troubleshooting for connecting and setting up
the ENET communication.

Table A-2 Troubleshooting for ENET Communication

Symptom
DeviceInstaller does not
detect your device.
Found device is not
reachable.
Typed text is not visible.
M370046-06
Check
Your ENET cable is not a cross
cable.
Power supply is not turned on.
The network that your computer is
on cannot reach the network that
the XTR with the ENET option is
connected to.
DeviceInstaller is not configured to
use the Ethernet card on your
computer that is connected to the
network which has the XTR with
ENET option on it.
Your network is not configured
properly.
Echo mode is not active.
Action
Use the correct ENET cross cable.
Turn the power supply ON.
Connect a laptop to the HUB or to
the switch that the XTR with the
ENET option is connected to, and
ping the computer you are trying
to use DeviceInstaller on. If no
response is seen, then contact your
network administrator and find
out if ICMP requests are being
filtered on the network and a
possible reason for not being able
to contact the computer.
See "Selecting a Network
Adapter" on page 2–11.
Contact your network
administrator.
Select Echo typed characters
locally in the ASCII Setup dialog
box of HyperTerminal.
A-3