Xantrex 850W Operating Manual page 48

Ethernet (ENET)
To set up for multiple power supplies and two computers:
1. Set up your computer as described in "Setting Up the Computer" on
2. Install the DeviceInstaller software on the PC you wish to use to
3. Configure each XTR unit with an ENET option. See the instructions
4. Create terminal connections for each of the XTR unit (s) with the
5. If more than one computer is going to be used, copy the filename.ht
The configuration is complete. You are now ready to use your system.
Controlling Your System
For every connected XTR unit, create a separate terminal session. This
should have been done according to the instructions in "Establishing
Communication with the Power Supply" on page 2–22. Also, open a
separate HyperTerminal session for each XTR unit that you wish to
control. An example of two XTR units in a system is shown in
Figure 2-33.
2-26
page 2–6. Repeat the procedure for each computer hooked up to the
system.
configure the XTR unit (s) with. See the instructions for "Software
Installations" on page 2–9.
for "Configuring the Device Using DeviceInstaller" on page 2–11
ENET option that were configured in step 3. See the instructions for
"Terminal Configuration" on page 2–18.
files saved in step 3 to a disk and copy them over to each computer
that you will be using to access the XTR unit (s) over the Ethernet. If
copying the files is not possible, repeat step 3 for each computer that
you wish to use.
M370046-06