Xantrex XKW 8-125 Operating Manual page 36

Installation
Load Connection
Assembly Instructions
1. Snap off the rectangular bushing attached to each piece of the strain relief. See
Figure 2.3 Strain Relief
2. Install bushings on strain relief pieces, as required. Cable diameter must be
3. Insert strain relief tab A into DC output connector slot A. Insert strain relief tab
4. Install screws in holes provided on outside of strain relief pieces. Thread through
Figure 2.4 Strain Relief Assembly
34
Figure 2.3.
(One piece, inside view)
between 0.120" and 0.650"
B into DC output connector slot B. See
to screw standoff inside opposite piece. Tighten to clamp outer jacket of output
cord securely, ensuring that the side of the strain relief slips into the
corresponding rabbet on the opposite piece.
.
Figure 2.4.
Operating Manual for XKW 1kW Series Power Supply