Transtalk Mdw 9040; Call Appearance Keys - Avaya 4400 User Manual

4400 and 6400 Series User Guide

TransTalk MDW 9040

The TransTalk MDW 9040 set is a wireless phone that can be used with the system. It is plugged in to a
DS port on either the base Control Unit or a DS expansion module. When using the set, it must be
configured to work with the system, by defining the button map to be used. This can be done by pressing
Menu on the phone and then using the arrow button to select Configuration, then Button Map and
then selecting Merlin Magix.
Although the TransTalk MDW 9040 has
local to the set. For this reason, when using this set, a system administrator must program the buttons
for you. See DSS Key Functions.
Features can also be accessed on these sets via short codes. For details of the normal default short
codes, see Default Speed Dial and Feature Codes.

Call Appearance Keys

By default, each phone is configured with 3 call appearance keys.
Your system administrator can change a call appearance key with:
• A Bridged Appearance
A bridged appearance key matches the status and operation of the Call Appearance Key on a pre-
defined colleague's phone. Hence, you can pick-up, make and receive calls on behalf of your
colleague.
• A Line Appearance
An IP Office exchange line (but not IP lines) can be allocated to you such that the status of that
line is displayed and you can use the line appearance key to make and receive calls.
•
Call Coverage Appearance
A call coverage appearance key alerts you when a pre-defined colleague is receiving a call. The
covered user does not need to be using call appearance keys. Hence, you can pick-up calls on
behalf of your colleague.
All of the above can only be allocated to you by your system administrator.
For details of Bridged, Line and Call Coverage Appearance Keys set-up and their operation, refer the IP
Office Key and Lamp Operation manual.
CAUTIONS
• Having more than two Call Appearance keys is very useful. When holding a call you can
answer/make another call and then switch between calls or transfer or conference. If you are set
to receive a call waiting indication, the waiting call is shown against the next call appearance key.
• Although the system administrator can replace the Call Appearance Keys with:
• A Bridged Appearance
• A Line Appearance
•
Call Coverage Appearance
• System Features
This would severely restrict the use of features such as conference and transfer.
It is for these reasons that it is strongly recommended that all Call Appearance keys remain at their
4400 and 6400 Series User Guide
IP Office 3.2
Menu, this button is local to the set and is used for features
default settings.
15-601074 Issue 11a (30th June 2006)
Page 2