Spo2 Button (Models 300 And 400); Config Button; Pwr Sav (Sleep Mode) - Critikon DlNAMAP PRO Series 100-400 Operation Manual

LEDs). Sleep mode is available only if the Monitor is
operating from its battery. Sleep mode conserves
power
while the Monitor is not in use. Once the Monitor
is in
Sleep mode, the user can return it to normal operation by
touching any button or the rotor.
54
(LEDs blanked and LCD displaying values
from
I
Pwr Sav (Sleep Mode)
Selection of this button allows the operator to specify the
time, in minutes, that elapses before the Monitor goes into
"sleep" mode
I
Main
t
I
Rotor
Save mode and time to be adjusted.
Config mode menu,
which allows the Power
Config Button
Selection of this button
returns the user to the Main menu.
displays the
1
Volume
The pulse tone volume can be set in the range of Off to 9.
The value Off should be selected
if no pulse tone is desired.
The volume
setting is stored
when the Monitor is turned off
and is restored to the user's preference each time the
Monitor is switched on.
Main
Selection of this button
[ Main
5
SpOZ pulse tone volume.
Volume
SpOz mode menu,
which
is used to set the
SpO, Button (Models 300 and 400)
Selection of this button displays the