Using The Printer; Installing The Paper - Critikon DlNAMAP PRO Series 100-400 Operation Manual

_
.
Source 2: Last
three BP readings
. Source 3: Error and warning messages
Note: Refer to "Display Button" in the "Using the Menu
System"
section for instructions
on setting Area 2.
Area 3
This area displays the time, the time lapsed since the last Auto
BP determination
(if
in Auto BP mode), the battery icon (if
operating on battery power, the time and battery icon toggle),
and the BP and Printer modes.
Using the Printer
Installing the Paper
Turn the PRO Monitor so that the side is facing you. While
grasping the side of the Monitor, firmly press the notched
indentations on the printer
door to
open it. The printer door will
pop open. With the Monitor powered on, place the roll of paper
into the compartment so that the end of the paper comes off
the top, and thread it between
the two
printer plates. As the
paper touches the plates, the paper will begin to auto-feed itself
into the printer. Feeding the end of the paper strip through the
slot in the door, firmly press the notched indentation on the side
of the printer door to close it. Use the paper release lever to clear
a paper jam or manually feed the paper.
Note: Make sure that the roll of paper is tightly wound.
SpO,
plethysmograph (Models 300 and 400)
data from one of
three different sources.
l
Source 1:
selected buttons appears light on a dark background.
Note: Some menus have six option buttons. In these cases,
there
is no space available to display the menu
title.
Area 2
This area displays