Switching The Monitor On And Off; Liquid Crystal Display (Lcd) - Critikon DlNAMAP PRO Series 100-400 Operation Manual

DINAMAP PRO Monitor on, push the
power
ON/OFF
switch
(16)
or
press the rotor (21).
As
the Monitor powers up, it will run
a short
self-test
routine, which will flash all the indicator lights and then
beep the warning speaker. After a few seconds the system
will be ready for operation, as indicated by the appearance
of the main menu on the
LCD (25).
To
switch the Monitor off, push the power
ON/OFF switch
(16)
again. This will terminate any measurements that may
be in progress and automatically deflate the cuff.
When the Monitor is operating on the internal battery only,
battery life is enhanced by the use of the sleep
mode.
However, the PRO Monitor will not enter sleep mode if an
alarm is active. If no controls are used and no
determinations are being made, the Monitor will enter sleep
mode after a time which can be preset by the operator. All
LED displays will be blanked except for a dash in the far-left
systolic position, and any existing readings will be
transferred to the LCD, which displays the message "Sleep
Mode Active." Moving the rotor or pressing a key will
"wake up" the Monitor.
liquid Crystal Display (LCD)
MENU AREA
Menu Area
This area displays the name of the menu that has option
buttons available for selection. Normal text in the menu
area appears dark on a light background, while the text of
@
To switch the
Getting Started
Switching the Monitor On and Off