Printer Alarms; Storage - Critikon DlNAMAP PRO Series 100-400 Operation Manual

.
placed in contact with adhesives, adhesive tapes, or
plasticizers such as those found in all PVC page protectors.
80%,
or
"C or relative
humidity over
OF/38
.
exposed to temperatures over 100
to direct sunlight,
DINAMAP PRO
header to be printed, thereby confirming that the paper is
installed correctly and that the printer is operational. The message
next to "PRNT" in Area 3 of the LCD will change to "Auto" or
"Manual" to identify the operating mode of the printer. After
power-off, the operating mode of the printer returns to the
previous user-selected setting (Auto or Manual) unless specified
otherwise in the Print button under the Service Button.
Storage
Store thermal paper in a cool, dry place. The printed strip
(thermal paper recording) should not be
exposed
-
No Paper" will appear in Area 2 of the LCD and an audible
alarm will sound. In addition, the message "No Paper" will
appear next to "PRNT" in Area 3 of the LCD. To clear the
alarm, press the rotor. The message in Area 3 of the LCD will
remain until new paper is installed and the printer door is
closed. (See "Using the Menu System.")
Installing new paper will cause the Critikon
DINAMAP@ PRO name on it.
If no print is
visible on the paper, check that the paper roll
has been
installed in
the correct position (refer to diagram). To tear
off
the printout, use a slight sideways action to pull the paper
sharply up across the serrated edge of the door.
Printer Alarms
If the Monitor is
the printer door
switched on with no paper installed or with
open, the message "No Paper" will appear
next to "PRNT" in Area 3 of the LCD. When new paper is
installed and the printer door is closed, the message will
change to "Manual" for Manual print or "Auto" for Auto print,
depending on the status before the paper change.
If the paper runs out during a print request or if an attempt is
made to print when no paper is installed, the message "Printer
Getting Started
Any time the paper is loaded, the printer automatically prints a
test strip with the