Critikon DlNAMAP PRO Series 100-400 Operation Manual page 14

.s>
- 18
SpOz artifact indicator LED: Illuminates when motion
artifact is detected (Models 300 and 400)
25 LCD (liquid crystal display): Displays all alarms, user
interface messages, and configuration options
26 Alarm silence switch: Alternately mutes and enables
audible alarms; when pushed once after alarm sounds
(silence
on),
switch lights to indicate that audible alarms
have been silenced for 2 minutes
27 AUTO BP key: Press to start Auto BP mode
28 Light sensor: Automatically measures ambient light to set
LED display intensity
29 START/STOP BP key: Press to start or stop a BP, Auto,
Stat, or Vitals determination
30 Cuff connector: BP cuff hose attaches here
% (Models 300 and 400)
24
3-digit red LED indicates oxygen saturation
in
SpOz display:
SpOz signals (Models 300 and 400)
21 Rotor: Used to highlight and select items in LCD
menus; if monitor is off, pressing rotor will switch
monitor on
22
Pulse BPM display: 3-digit yellow LED shows pulse rate
in beats per minute
23
SpOz pulse indicator: Yellow LED in heart symbol flashes
to indicate that real-time pulse rate measurements are
being derived from
mmHg and shows instantaneous cuff
pressure during BP determination
20
3-digit red LED indicates
measured MAP in
SpOz
sensor extension cable
attaches here (Models 300 and 400)
19
Mean arterial pressure display:
SpOz
sensor connector:
14 External power indicator: Green
LED indicates external
power status and battery charging status of monitor
15
Temperature probe connector: Temperature probe cable
attaches here (Models 200 and 400)
16
ON/OFF
switch: Controls on/off state of monitor; push
for power on and push again for power off
17 Battery power indicator: Yellow LED indicates operation
and charge status of internal battery
18