Critikon DlNAMAP PRO Series 100-400 Operation Manual page 29

-
If an alarm is actively sounding, an audible
tone will not
sound.
l
If tissue contact is lost, the chase sequence on the
temperature display
(12)
stops. If tissue contact is not
made within 1 minute, the Monitor will alarm.
Th.e Monitor
will not beep at final temperature. It will continue to
monitor the patient's temperature until the probe is
removed from the patient and returned to the probe
holster.
l
To cool the temperature probe down, wipe with alcohol.
l
If there is a long delay from the time the probe is
removed from the probe holster until it is inserted into
the patient's mouth, it is possible that the instrument will
not display a final temperature.
If
this occurs, insert the
probe into the probe holster, remove it again, and start a
new measurement.
(34.4" C) when taken out of the probe holster, the
thermometer will not be able to perform a predictive
measurement. Instead, the thermometer will
automatically go
into monitor mode. The temperature
reading will then flash. A correct final temperature
reading may require 3 minutes or longer.
4.
Using the Monitor
When the determination is complete, an audible tone
sounds and the temperature appears on the display.
Record the temperature and
remove the probe. Discard
the disposable cover by holding the probe as you would
a syringe and pressing the button on the probe handle.
Place the probe
in the probe holster. Once you place the
probe
in the probe holster, the temperature values will
be cleared.
Notes
l
If the probe tip temperature is 94.0" F or higher