Oce TCS300 User Manual page 49

Press the key for 'Next'.
4.
The screen displays the message 'Select item.'
Use the lower softkeys to select 'Network settings adapter 1'.
5.
[35]
Press the key for 'Next'.
6.
The screen displays the current settings for the selected adaptor. The system
7.
indicates which settings are received through DHCP with a round dot.
Use the lower softkeys to scroll through the settings. Press the key for 'Edit', to
change the network settings.
The screen displays 'Use DHCP server for adapter 1?'. Use the lower softkeys to
8.
select 'Yes' or 'No'.
[36]
Continue with step 9 when you select 'Yes'.
Continue with step 10 when you select 'No'.
Press the key for 'Undo', to cancel your settings.
After you select 'Yes', press the key for 'Next'.
9.
The wizard will lead you through a series of dialogues where you can enable DHCP
or define the IP addresses for the following.
The default gateway
DNS
WINS.
Press the key for 'Apply' to confirm the settings and to exit the wizard
The system indicates whether you have to reboot the Océ Power logic controller to
apply the new network settings. This can, for example, be the case when settings are
received through DHCP. When no indication appears, you do not need to reboot the
Océ Power logic controller.
Note: When 'Synchronise controller power on / off' is set to 'On', you must turn the
printer off and on to reboot the Océ Power Logic controller.
After you select 'No', press the key for 'Next' to manually define the network settings.
10.
Configure the network settings of the Océ TCS300
49