Oce TCS300 User Manual page 134

Replace the media
[72]
[72] Remove the flanges
How to load a new media roll
Insert the flanges in both ends of the new media roll.
1.
Press the handles down to fasten the flanges.
2.
Put the saddles into position at the ends of the track.
3.
[73]
[73] Saddles
Use both hands to place both flanges in the green saddles on the printer.
4.
Use both hands to slide the medium under the paper guide. Place the media on the
5.
printer as shown in the figure below.
134 Chapter 8 Maintain the Océ TCS300 printer