Table of Contents
Advertisement
Replace a defective printhead
Note: If you cancel the calibration, the printer restarts the calibration process when
a new print job starts.
Note: If the printer rejects the new printhead during the 'Replace printhead'
procedure, remove the printhead, clean the contact area with a lintfree cloth and
re-insert the printhead.
Note: Also check the maintenance cassette after you replaced a printhead.
(see
'How to remove the maintenance cassette' on page
148) Check if all wipers are
present and clean. Excessive ink remains on the wipers can damage the printheads.
Wipe the wiper blades with a moist cloth to increase the lifetime of the printheads.
146
Chapter 8 Maintain the Océ TCS300 printer
Advertisement
Table of Contents
