Table of Contents
Advertisement
The on-line mode and the off-line mode
[11] Overview Océ TCS300 printer wizards
Wizard
'Feed & cut'
[12]
'Change media type'
[13]
'Optimise print quality'
[14]
'Replace printhead'
[15]
'Replace cassette'
[16]
'Replace ink tank'
[17]
'Display counters'
[18]
'Configure system'
[19]
'Language'
[20]
28
Chapter 2 Get to know the Océ TCS300 colour printing system hardware
Reference
(see 'Cut the output and clean cut a roll of media' on page
Use this wizard to do the following.
Cut the output.
Clean cut a roll of media. Use this option to cut the media on the
roll so that the edge is straight.
(see 'Replace the media' on page
Use this wizard to correct the type of media when an incorrect media
type was defined when the roll was loaded.
(see 'Use the Optimise print quality wizard' on page
Use this wizard to correct problems with the output quality. The
wizard performs the following actions.
Detect weak or failing nozzles.
The Océ TCS300 automatically compensates the detected
nozzles in future prints to make sure that print quality is optimal.
Align the printheads and optimise the paper transport.
(see 'Replace a defective printhead' on page
Use this wizard to replace a defective printhead, after the printer
operator panel displays an error message and prompts you to replace
the defective printheads. Only replace the printheads the system
indicates.
(see 'Replace the maintenance cassette' on page
Use this wizard to replace the maintenance cassette, after the printer
operator panel displays the message 'Maintenance cassette nearly
full.'.
(see 'Replace the ink tanks' on page
Use this wizard to replace the ink tank when the ink level indicator
on the printer operator panel shows 0%. The indicator flashes when
the ink tank is empty.
Select this wizard to check the amount of media and ink that is used
since the system was installed. Press the softkey for 'Finish' to return
to the off-line screen.
(see 'Configure the network settings of the Océ TCS300' on page
You can perform the following actions in the 'Configure system'
wizard.
Configure the network settings.
Clear the set memory.
Toggle between the two languages that you defined in the Océ
Settings Editor.
(see 'Define the display language of the Océ
TCS300' on page
44)
132)
118)
142)
147)
139)
78)
48)
Advertisement
Table of Contents
