Table of Contents
Advertisement
Replace the media
lower softkey and select 'More...'. Then a list displays of all the media types that you
can select.
Press the key for 'Next' to enter the cut option screen. The system displays the
2.
question 'Cut?'
Use the lower softkeys to select the cut option for the media.
3.
[76]
[76] Select the cut option
Select one of the following.
'Yes, long strip'
Cut the media with a full roll rotation feed (50 cm) before the printer cuts the
media. You can use this option when the media is damaged or polluted with, for
example, tape residue.
'Yes, short strip'
Cut the media with the shortest possible strip (20 cm).
'No'
No media cut.
Press the key for 'Finish' to confirm the settings and to exit the wizard.
4.
How to correct the media type defined on the system
Attention: You need only to correct the type of media when an incorrect media
type was defined when the roll was loaded.
When you define a type of media that is different from the media type loaded on
the system, the print quality decreases and pollution of the system can occur.
136
Chapter 8 Maintain the Océ TCS300 printer
Advertisement
Table of Contents
