Table of Contents
Advertisement
An introduction screen displays the message 'Use this wizard to optimise the print
quality.'
[66]
Press the key for 'Next'.
4.
The screen displays the message 'Select roll to use'.
You can only calibrate on the defined media types
printing optimisation' on page
media, the system asks you to load the correct media. When calibration is possible
with one of the rolls, the system automatically uses the correct roll of media. When
calibration is possible with both rolls, continue with step 5.
Press the lower softkeys to select a media roll for the calibration.
5.
[67]
Press the key for 'Next'.
6.
The screen displays the message 'Preparing calibration...' The system prepares for
the quality check.
[68]
The screen displays feedback about the calibration process. The system does a
nozzle failure recovery and alignment.
You can stop the calibration process at any time. Press the key for 'Cancel' to stop the
calibration process.
In case more than 75 nozzles fail, a 'Printheads failing' message appears. Then you
must replace the printhead, using the 'Replace printhead' wizard .
Use the Optimise print quality wizard
(see 'Set up unattended / overnight
67). When calibration is not possible with the loaded
119
Advertisement
Table of Contents
