Pre-Operation Inspection; Starting Procedure; Driving - E-TON CXL-150 Owner's Manual

When reinstalling the battery, be sure to connect
the red cable to the positive (+) terminal and the
black cable to the negative (-) terminal.
The battery should be replaced every three years
or when it no longer holds a charge.
Do not expose the battery, for extended periods of
time, to freezing temperatures. If the battery has
been frozen it will need to be replaced. There is
an inline fuse on the positive lead of the battery to
protect the wiring system from over loads. If your
starter motor will not turn over and the battery is
fully charged, check the inline fuse on the unit.
Replace the fuse with a 7A fuse.

Pre-Operation Inspection

procedure
The following procedure must be
performed before each operating session.
Checking your ATV takes only a few minutes
and may save you from serious injuries and
costly repairs.
1. Check engine oil level.
2. Check engine fuel level.
3. Check brake operations and brake fluid
level.
4. Check tire condition and pressure.
5. Check drive chain condition and slack.
6. Check throttle operation and free play
adjustment.
7. Check engine stop switch for proper
operation.
8. Check steering system. Look for free
and smooth operation. Check all
fastening hardware.
Copyright ©2008-2009 ETON America, all rights reserved.
9. Check all nuts, bolts and other
fasteners for loose conditions.
10. Inspect unit for any broken or damaged
parts.
11. Check all indicator lights and switches
for proper operation.
12. Insure you are wearing proper clothing
and protective gear: Helmet, Gloves
Pads, etc.

Starting Procedure

The following procedure must be followed
each time you start your unit.
Park the unit on a level surface and lock the
parking brake. Place the transmission gear
selector shaft in the "N", Neutral, position. Turn
the engine stop switch to the "ON" position.
Turn the ignition key switch to the "ON"
position. Apply slight pressure to the throttle
lever. Press the starter button on the left-
handle bar.
Your unit should start within 10 seconds of
pushing the starter button. If the unit fails to
start check the following.
1. Ignition key switch is "ON"
2. Engine stop switch is "ON".
3. Parking Brake Locked "ON".
4. Transmission selector switch in the "N"
position
Driving your ATV
Your ATV should only be driven in an area that
is designated for this use. Insure that the area
is free of obstacles and other dangers that
could cause a loss of control. Check with your
local authorities for any regulations regarding
the use of your ATV.
Always keep your feet on the footrests and
your hands on the handle bar grips while
operating your ATV. Doing so will give you the
best control of the unit.
Start your ATV by following the starting
procedure above and allow the engine a few
minutes to warm up before releasing the
parking brake.
Start the unit by slowly increasing the throttle
until the unit begins moving.
Page 20