Air Filter; Braking Systems; Front Brake Inspection - E-TON CXL-150 Owner's Manual

Air Filter

Air Filter Maintenance
To maintain the highest performance from your
engine and to reduce excessive wear that could
cause engine failure the engine requires a
continuous flow of clean air. Air is taken into the
engine through an air filter to clean the air prior
to mixing it with fuel in the carburetor.
During normal operation the filter accumulates
dirt from the air and will need to be cleaned to
maintain the proper air flow. The filter should
be cleaned every 30 days, more often if you
ride in a dusty or dirty environment and the
element should be replaced every year.
The air filter box is located at the front of the
engine under the fuel tank.
To clean the filter
Remove the air filter box.
Copyright ©2008-2009 ETON America, all rights reserved.
Remove the filter element from the air box and
replace the filter element as needed.

Braking Systems

Your ATV unit is equipped with dual front
mechanical drum brakes and a rear hydraulic
disc brake. The front brakes are applied by
squeezing the brake lever on the right-handle
bar, while the rear brake is applied by squeezing
the brake lever on the left-handle bar.
Proper maintenance of the brake system is a
necessary part of safe operation of your unit. The
brake systems should be inspected and tested
before each riding session.
Front Brake System
Visually inspect the brake cables for any signs of
wear. Inspect the cables for frays and kinks that
inhibit the free movement of the cable. Replace
frayed or kinked cable before operating your unit.
Inspect the cables for rust or corrosion. Replace
any brake cable that show signs of corrosion as
this could cause a reduction in cable strength that
can lead to the cable breaking.
Page 15
Inspection