Electrical Battery - E-TON CXL-150 Owner's Manual

Adjusting the throttle cable
The cable should be adjusted to allow for ⅛" free
travel before the throttle engages the carburetor
throttle slide. Slide the adjuster cover down the
cable to uncover the adjuster assembly. To adjust
the cable's free travel, loosen the locking nut of
the cable adjuster, and turn the adjuster nut until
there is ⅛" free travel in the lever. Tighten the
locking nut to secure the adjusting nut. Slide the
cover back over the adjuster assembly.
Copyright ©2008-2009 ETON America, all rights reserved.
The speed of the unit can be adjusted by
adjusting the throttle stop screw to limit throttle
travel. Loosen the throttle stop screw locking nut
and turn the throttle stop screw clockwise to
reduce the throttle travel thus reducing the
maximum speed of the unit. Turning the stop
screw counter clockwise will increase the throttle
travel thus increasing the maximum speed of the
unit. Tighten the stop screw locking nut when the
desired throttle travel has been established.

Electrical Battery

The unit's battery is located under the seat and
supplies electrical power to the unit. The battery
is a 12 volt jell acid type that contains no liquid
electrolyte. The battery should be removed from
the vehicle when stored for extended periods
and charged before being replaced in the unit.
Use a trickle charger set at 12 volts to recharge
the battery to full charge before replacing it in
the unit.
Page 19