Tie-Rod Inspection; Kingpin Inspection; Steering Shaft Removal; Steering Shaft Holder Inspection - E-TON VIPER 50 ST Service Manual

Tie-rod Inspection

Inspect the tie-rod for damage or bending. Inspect the
ball joint rubbers for damage, wear or deterioration.
Turn the ball joints with fingers. The ball joints should
turn smoothly and quietly.

Kingpin Inspection

Inspect the kingpin for damage or cracks.

Steering Shaft Removal

Remove the handle bar cover and handle bar.
(See paragraph 8-3)
Remove the front fender. (See paragraph 10-1) Remove
handlebar lower holder.
Unscrew steering shaft holder bolt, remove steering shaft
holder.
Take off the cotter pin below steering shaft. Unscrew the
steering shaft fixed out below shaft. Pull steering shaft
carefully.

Steering Shaft Holder Inspection

Remove the steering shaft.
Remove the bushing from the shaft.
Inspect the bushing for damage or wear, replace if
necessary. Measure the bushing inner diameter.
Maximum limit: Ø39.5 mm