Inline Fuel Filter; The Seat - E-TON ROVER Owner's Manual

Inline Fuel Filter

This vehicle is equipped with an inline fuel
filter to prevent dirt and debris from entering
the carburetor and engine.
Check the filter for dirt or damage before
each ride and at each refueling. Replace
the filter if dirty or damaged.
The filter should be replaced every 600
hours of operation and at the start of each
season.
To replace the filter, first turn the fuel valve
to the "OFF" position.
Then carefully compress the wire clamp
rings until the clamp is free of the fuel line.
Slide each clamp away from the filter about
3/4".
Remove the filter from the fuel line by holding
the line and pulling the filter. Install the new
filter by inserting the filter into the fuel line
Turn the fuel valve to the "ON" position and
returning the clamps to the original position.
check for leaks. Inspect the fuel lines for
cuts, abrasions and deterioration. Replace
fuel lines as needed.
DO NOT operate or start the engine if the
fuel filter or lines are leaking. Leaking fuel
can cause a fire.
Copyright ©2008-2009 ETON America, all rights reserved.
CONTROL FEATURE CONTROL FEATURE
You can change the position of sest and
head rest to make a comfortable position
of you.
To change the seat position, you need to
lossen two bolts at the seat bottom right
hand side.
To move the head rest, you need to take
out the bolts.
Move the head rest to a correct position,
then tighten the bolts.
Page 12

The Seat

Only For ROVER
(CEILING)