Setup; Lamp; Maximizing The Life Of Your Lamp - Chauvet Intimidator Spot 250 User Manual

3. S
ETUP

Lamp

You will need to install a lamp prior to the initial operation of the fixture. A 250W MSD discharge lamp
is included.
Warning! When replacing the lamp, please wait 15 minutes after powering down to allow the
unit to cool down! Always disconnect from main power prior to lamp replacement.
Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp
with alcohol and wipe it with a lint free cloth before installation.

Maximizing the life of your lamp

To ensure the longest and most efficient use of the lamp always wait
between 10 and 15 minutes before re-applying power after a shutdown.
Failure to do so could result in premature aging of the lamp and failure to the
electronics that drive it.
Never turn off the power to the unit while the lamp is striking. Always wait 15
minutes after powering on the fixture before powering down. Turning off the lamp
during striking may permanently damage the lamp.
Intimidator™ Spot 250 User Manual
8
8/24/2009 3:19 PM