Table of Contents
Advertisement
3. S
ETUP
AC Power
Fuse Replacement
3. Setup
This fixture is auto-ranging and runs on 100~240 VAC, 50/60 Hz power.
To determine the power requirements for a particular fixture, see the label affixed to the back
plate of the fixture or refer to the fixture's specifications chart. A fixture's listed current rating
indicates its average current draw under normal conditions.
Always connect the fixture to a switched circuit. Never connect the fixture to a rheostat
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used only
as a 0 to 100% switch.
Always connect the fixture to a circuit with a suitable electrical ground.
Disconnect the power cord before replacing a fuse.
Always replace with the same type & rating fuse!
1.
With a flat head screwdriver wedge the fuse holder out of its housing.
2.
Remove the damaged fuse from its holder and replace with exact same type fuse.
3.
Insert the fuse holder back in its place and reconnect power.
The fuse is located
inside this
compartment.
Remove using a flat
head screwdriver.
6
1/17/2011 6:15 PM
Advertisement
Table of Contents
