Table of Contents
Advertisement
User Configurations
T o set th e pa n to i nv er tin g o r non - inv e rt i ng:
1)
Press the <MENU/ESC>.
2)
Select the desired option by using the <UP> and/or <DOWN> button to navigate through the
display until you reach "3-Pan".
2)
Press the <ENTER> button.
Note: you may select "Normal" using the <UP and/or <DOWN buttons and press the <ENTER>
button for non-inverting; or, you may select "Reverse" for inverting.
T o set th e til t to i nv e rti ng or no n - inv er tin g:
1)
Press the <MENU/ESC>.
2)
Select the desired option by using the <UP> and/or <DOWN> button to navigate through the
display until you reach "4-Tilt".
2)
Press the <ENTER> button.
Note: you may select "Normal" using the <UP> and/or <DOWN> buttons and press the <ENTER>
button for non-inverting; or, you may select "Reverse" for inverting.
T o act iv at e /de a ctiv at e mov e - in- b l ac k f un c tion( s) :
This fixture has a built-in function that will offer greater ease in programming. This is called the move-
in-black function. This is the option of stating that the fixture will blackout (close shutter) between 2
different steps of operation via DMX. You may enable and disable this function remotely via the
control channel in DMX operation. See the below instructions for this operation for the pan/tilt
movement.
1)
Using a DMX controller, bring channel 14 (in advanced mode) to a value of [010
2)
Hold this value for 3 seconds.
3)
After 3 seconds, you may bring the channel back down to a value of [000].
4)
The fixture now has saved this setting in the onboard memory and will retain it. If you wish to
disable this function, then you may bring channel 14 to a value of [015
You may follow the above steps for the pan/tilt, color, gobo, and combined movement by locating the corresponding DMX
values in the DMX values section of this user manual.
Intimidator™ Spot 250 User Manual
19
014].
019].
8/24/2009 3:19 PM
Hide quick links:
Advertisement
Table of Contents
