EFORE EGIN What is included 1 x LED-BANK4™ 1 x Coupling Bracket (Striplight attachment) IEC Power cable Warranty Card & User Manual Unpacking Instructions Immediately upon receiving a product, carefully unpack the carton, check the contents to ensure that all parts are present, and have been received in good condition.
Run Speed Flash Speed Flash Speed No Function For a detailed view of DMX values turn to the DMX Channel Values on page 12 in the Appendix section. LED-BANK4 User Manual RGB Mode ESCRIPTION ESCRIPTION DMX: (210~219) RGB Color Mix...
Product Overview Built in microphone DMX input & output connectors LED display Mode Indicator Mode Enter LED-BANK4 User Manual Control panel Microphone COLORbank™ sensitivity dial data link Number display Striplight, linear attachment accessory Down Introduction 76 LEDs per surface area...
ETUP Power The LED-BANK4™ can operate in voltages between 100V~240V 50Hz or 60Hz. It is equipped with an auto sensing transformer. To determine the power requirements for a particular fixture, see the label affixed to the back plate of the fixture or refer to the fixture’s specifications chart.
Color Fade Automatic Program (sound) S dAd DMX channel addressing Re-initialize fixture S Aad Re-establishes correct number of down-link fixtures for sequential color chase runs. LED-BANK4 User Manual Mode Indicator Mode ( P ) R ROGRAM PEED Red (001-100) Function & number display...
Solid flashing colors 008-013 Color chase programs 014-020 Sequential color chase patterns RGB (manual color mix) Color fade Auto run (sound active only) LED-BANK4 User Manual Master/Slave Link output Master 3 Pin XLR DMX cable Slave Slave DMX signal output does not continue on M/S linked fixtures.
7. Press the Up/Down buttons to return to the DMX control state, the display will read [S dAd]. 8. Repeat this for every fixture you wish to address. LED-BANK4 User Manual Universal DMX Controller You can use the...
6. Press the Up/Down buttons to return to the DMX control state, the display will read [S dAd]. LED-BANK4 User Manual Universal DMX Controller DMX Input...
XLR male to female connectors. The shield connection is pin 1, while pin 2 is Data Negative (S-) and pin 3 is Data positive (S+). CHAUVET carries 3-pin XLR DMX compliant cables, DMX-10 (33’), DMX-4.5 (15’) and DMX-1.5 (5’)
Package must be clearly labeled with a Return Merchandise Authorization Number (RA #). Products returned without an RA # will be refused. Call CHAUVET and request RA # prior to shipping the fixture. Be prepared to provide the model number, serial number and a brief description of the cause for the return.
Main ... 20mm Glass 2A, 250W Fast Blow LEDS Quantity of LEDs ...(304) Total divided into 4 surface areas ... (Red 40, Green 36, Blue 36) in each area ORDERING INFORMATION COLORbank™ 4 ... LED-BANK4 FUSE 2A 250W... P170FUSE002 Technical Support Address: Service Dept.
Need help?
Do you have a question about the LED-BANK4 and is the answer not in the manual?
Questions and answers