Table of Contents
Advertisement
Setup
3. S
ETUP
AC Power
AC Plug
Fuse
Replacement
Power Linking
DMX Linking
DMX
Personalities
-6-
Each Rogue™ R1 Wash has an auto-ranging power supply that works with an input voltage
range of 100 to 240 VAC, 50/60 Hz. To determine the power requirements for each Rogue™ R1
Wash, refer to the label affixed to the product. You can also refer to the
chart in this manual.
The listed current rating indicates the maximum current draw during normal operation. For more
information, you may download Sizing Circuit Breakers from the Chauvet website:
www.chauvetprofessional.com.
·
Always connect this product to a protected circuit with an appropriate electrical
ground to avoid the risk of electrocution or fire.
·
To eliminate unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the product from power via breaker or by unplugging it.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel serves only as a 0 to 100% switch.
The Rogue™ R1 Wash comes with a power input cord terminated with a Neutrik® powerCON®
A connector on one end and an Edison plug on the other end (U.S. market). If the power input
cord that came with your product has no plug, or if you need to change the Edison plug, use the
table below to wire the new plug.
Connection
AC Live
AC Neutral
AC Ground
1. Disconnect this product from the power outlet.
2. Using a flat-head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove the blown fuse and replace with another fuse of the same type and rating
(F 4 A, 250 V).
4. Screw the fuse holder cap back in place and reconnect power.
Make sure to disconnect the product's power cord before replacing a blown fuse. Always
replace the blown fuse with another of the same type and rating.
The Rogue™ R1 Wash supports power linking. You can power link up to 10 products at 120 V;
up to 18 at 208 V; or up to 21 at 230 V.
This product comes with a power input cord. Power linking cables are available from Chauvet
for purchase.
You can link the Rogue™ R1 Wash to a DMX controller using a 3- or 5-pin DMX connection. If
using other DMX-compatible products with the Rogue™ R1 Wash, you can control each
individually with a single DMX controller.
The Rogue™ R1 Wash uses a 3- or 5-pin DMX data connection for the 14, 15, 19 or 21-channel
DMX personalities.
·
Refer to the
Introduction
·
Refer to the
Operation
these personalities.
·
The
DMX Values
section provides you with detailed information regarding the DMX
personalities.
If you are not familiar with or need more information about DMX standards, Master/Slave
connectivity, or the DMX cables needed to link this product to a DMX controller,
download the DMX Primer from the Chauvet website: www.chauvetprofessional.com.
Wire (U.S.)
Black
White
Green/Yellow
chapter for a brief description of each DMX personality.
chapter to learn how to configure the Rogue™ R1 Wash to work in
Technical Specifications
Wire (Europe)
Brown
Yellow or Brass
Blue
Green/Yellow
Rogue™ R1 Wash User Manual Rev. 2
Screw Color
Silver
Green
Advertisement
Table of Contents
