EFORE EGIN What is included 1 x LED-BAR COLORbar™ Warranty Card Users Manual Unpacking Instructions Immediately upon receiving a product, carefully unpack the carton, check the contents to ensure that all parts are present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear damaged from shipping or the carton itself shows signs of mishandling.
Green Section 2 Blue Dimmer Green Section 3 Blue Dimmer Green Section 4 Blue Dimmer LED-BAR User Manual 6 Channel Configuration RGB Mix Auto Run & Sound Active ESCRIPTION ESCRIPTION Control Configurations Patterns Color 1 Color 2 Speed Fade 2005-11-22/09:18...
Product Overview IEC Plug for AC Input Power Switch Switch selectable AC Voltage Control Panel DMX Output IEC AC Output LED-BAR User Manual DMX Input Fuse Hanging yoke Sound sensitivity knob Introduction 2005-11-22/09:18...
1. Align the clamp screw with the center hole on the yoke and tighten. 2. Verify the structure can hold 10 times the weight of all to-be installed fixtures. 3. Adjust the angle on the yoke arm as necessary. LED-BAR User Manual NTERNATIONAL Live...
Use the [UP] or [DOWN] buttons to set the display to [] for Slave mode. (this should be the default setting) 4. You can also run the fixtures in an automatic stand-alone mode by simply setting all fixtures to run as master units. LED-BAR User Manual Green Blue Yellow...
1. Press the [MENU] button on the control panel until the display reads []. 2. Use the [UP] and [DOWN] buttons to increase or decrease channel values until the desired value is displayed. 3. Remember to set function [] to ON in order to enable DMX control. LED-BAR User Manual Appendix 2005-11-22/09:18...
XLR male to female connectors. The shield connection is pin 1, while pin 2 is Data Negative (S-) and pin 3 is Data positive (S+). CHAUVET carries 3-pin XLR DMX compliant cables, DMX-10 (33’), DMX-4.5 (15’) and DMX-1.5 (5’)
Package must be clearly labeled with a Return Merchandise Authorization Number (RA #). Products returned without an RA # will be refused. Call CHAUVET and request RA # prior to shipping the fixture. Be prepared to provide the model number, serial number and a brief description of the cause for the return.
Need help?
Do you have a question about the LED-BAR and is the answer not in the manual?
Questions and answers