Fuse Replacement; Replacing Gobos - Chauvet Intimidator Spot 250 User Manual

Fuse Replacement

With a flat head screwdriver wedge the fuse
holder out of its housing. Remove the damaged
fuse from its holder and replace with exact
same type fuse. Insert the fuse holder back in
its place and reconnect power.

Replacing Gobos

1) Be sure the fixture is not powered or connected to mains.
2) Remove the top cover by removing the 4 screws with a Phillips #2 screwdriver.
3) With your hand, move the gobo wheel to the desired gobo to change.
4) Remove the slot-n-lock gobo by pressing it up and away of the gobo wheel
and sliding it out of the fixture.
5) You may now replace the gobo easily by removing
the tension ring. This may be done with a small tool.
6) Replace the slot-n-lock gobo assembly.
7) Replace top cover and 4 cover screws.
Gobo Wheel
1
2
3
4
Intimidator™ Spot 250 User Manual
Disconnect the power cord before replacing a fuse and always
replace with the same type fuse.
7
6
5
10
The fuse is located
inside this
compartment.
Remove using a flat
head screwdriver.
Top cover screws
3
2
4
8/24/2009 3:19 PM