Setup; Ac Power; Power Requirements; Power Cord - Chauvet followspot 1200 User Manual

Setup

3. Setup

AC Power

Power Requirements

Power Cord

Power Cord Pin Out

Fuse Replacement

Fuse Holder Diagram
Followspot 1200 User Manual Rev. 5
The Followspot 1200 has two AC input voltage settings, 208 and 230 VAC, and two AC
frequency settings, 50 and 60 Hz. The voltage and frequency settings require changing
the connections on the corresponding terminal strip. See the Voltage and Frequency
Selection section in this chapter.
Always connect the Followspot 1200 to a protected circuit with an appropriate
electrical ground to avoid the risk of electrocution or fire.
To determine the power requirements for the Followspot 1200 see the label affixed to
the fixture. Alternatively, you may refer to the specifications chart in the Technical
Information chapter of this manual.
The listed current rating indicates the maximum current draw during normal operation.
Please refer to the Sizing the Circuit Breakers section in the Appendix chapter of this
manual.
The fixture side of the Followspot 1200's power cord enters the control panel through a
strain relief boot. This side of the power cord is hard-wired to the fixture. Therefore,
there is no removable power connector on the control panel.
The outlet side of the power cord is bare-ended. This way, the users will be able to
equip it with the power plug that best matches the local standards and regulations.
Connection Wire (U.S.)
AC Live
Black
AC Neutral
White
AC Ground Green/Yellow
Never connect the Followspot 1200 to a rheostat (variable resistor) or dimmer
circuit, even if the rheostat or dimmer channel serves only as a 0 to 100% switch.
1) With a Philips screwdriver, unscrew the fuse holder out of its housing and remove
the blown fuse from its holder.
2) Replace the blown fuse with a fuse of the exact same type and rating.
3) Replace the fuse holder in its place, and reconnect power.
Make sure to disconnect the fixture's power cord before replacing a blown fuse,
and always replace it with a fuse of the same type and rating.
Illuminated
On/off Switch
Fuse Holder
-6-
Wire (Europe) IP-66 Pin
Brown 1
Blue 2
Green/Yellow 3
Power Cord
Rubber Boot
Screw Color
Yellow or Brass
Silver
Green