The Mx7 Hand Held Computer; Reboot Sequence; Warm Reset; Cold Reset - LXE MX7 User Manual

Reboot Sequence

When the Windows CE desktop is displayed or an application begins, the power up (or reboot)
sequence is complete. If you have previously saved your settings, they will be restored on reboot.
Application changes are saved when OK is clicked on an application applet.

Warm Reset

Hold down the Power key for 15 seconds until the display blanks, then release the key. A warm
reset does not affect the operating system and no data loss occurs. The network connection will
need to be re-established.

Cold Reset

Important:-- Because of the extreme nature of the Cold Reset, LXE recommends that
the Cold Reset be used only as an emergency procedure and the Warm Reset be used
Tap | Run and type COLDBOOT.EXE. Tap the OK button to coldboot the MX7. The default
settings are restored when the device powers on again.
Calibrating the touchscreen will need to be performed when the cold boot process is complete.
If needed, change the MX7 Time and Date from it's factory default value by tapping the
Settings | Control Panel | Date/Time icon.

Saving Changes to the Registry

The MX7 saves the registry when you:
•
Tap the
•
Perform a Suspend / Resume function (by pressing the Pwr key and then pressing it again).
•
Install Restart in the Start menu by
The registry save process takes 5 – 10 seconds.
The registry is automatically saved every 20 minutes. It is also saved every tenth time the registry
settings are changed. Registry settings are changed when control panel applet (e.g. Date/Time)
parameters are changed by the user and a warm boot was not performed afterward.
When you tap
changes and settings are lost.
E-EQ-MX7OGWW-C

The MX7 Hand Held Computer

whenever necessary.
| Run | and type Warmboot.
| Run | and type Coldboot, factory default registry settings are loaded. All user
| Run | CTL RESTART=1 and then tap
|
| Restart.
MX7 User's Guide