Front I/O And Power Switch Assembly - HP ProDesk 405 G2 Microtower Maintenance And Service Manual

Front I/O and power switch assembly

1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. From the inside of the computer, disconnect the three front I/O cables from the following system board
connectors:
● PB/LED
● FRONTUSB3.0
●
FRONT AUD
NOTE:
48 Chapter 5 Removal and replacement procedures: Microtower
(Access panel on page
(Front bezel on page
System board layout may vary.
(Preparation for disassembly on page
24).
25).
23).