Chapter 3. Configuration
T1/E1 Circuit Protection
Choose which T1/E1 lines to protect (see Figure 3-10). If a T1/E1 is
set to D
controller cards to switch. If set to E
could cause the cards to switch (depending on the P
T
HRESHOLD
The P
E
failure of a single protected (enabled) line to cause a card switch, set
the P
Select S
value at the same time. See Set Multiple on page 3-7 for a
description of the S
D
3-10
, then the failure of that one line will not cause the
ISABLED
setting in this menu).
T
ROTECTION
HRESHOLD
lines must fail before a card switch occurs. If you want the
NABLED
T
ROTECTION
HRESHOLD
M
to set any or all of the T1/E1s to the same
ET
ULTIPLE
ET
.
ISABLED
MX2800 User Manual
Figure 3-9. Loopback Detection Menu
NABLED
setting determines how many of the
to 1. Choices include 1 through 28.
M
selection, entering E
ULTIPLE
, then the line's failure
ROTECTION
or
NABLED
61200290L1-1