Table of Contents
Advertisement
Chapter 3. Configuration
XCV Threshold
Set a limit on code violations (CVs) accepted by the unit over an
individual T1/E1 line before it switches controller cards. If set to
D
controller cards. The threshold limits are described in the following
chart:
Setting
SYSTEM MANAGEMENT
Configure the MX2800 for management through SNMP, Telnet, or a
VT 100 interface (see Figure 3-12). Embedded SNMP and Telnet are
available via a SLIP/PPP modem port or 10BaseT ethernet
interface. This menu also includes options used to customize your
unit's alarm and trap generation, security setup, and equipment
identification.
3-12
, code violations will not cause the unit to switch
ISABLED
The unit switches controller cards if...
more than one out of every 1,000 bits received on a
-3
1E
T1/E1 line contains a code violation.
more than one out of every 10,000 bits received on a
-4
1E
T1/E1 line contains a code violation.
more than one out of every 100,000 bits received on a
-5
1E
T1/E1 line contains a code violation.
more than one out of every 1,000,000 bits received on
-6
1E
a T1/E1 line contains a code violation.
Figure 3-12. System Management Configuration Menu
MX2800 User Manual
61200290L1-1
Advertisement
Table of Contents
