Table of Contents
Advertisement
Dialout On Trap
Enable or disable the MX2800's ability to dial out to report traps.
M
plain ASCII with the following information:
•
•
•
•
When M
logs into the PPP/SLIP host and reports the error conditions to the
hosts designated under T
on page 3-19).
Answer on Ring
Enable or disable the MX2800's ability to accept incoming calls. If
enabled, incoming calls are automatically answered by the
MX2800, allowing you to remotely perform management functions.
Modem Mode
Select the
or SLIP). The
provides a telephone line (POTS) for connection to the internal V.34
modem. This setting applies only if the M
Management Port on page 3-13) is set to M
Modem Baud Rate
Set the maximum operating speed of the
4800, 9600, 19200, and 38400 bps).
Hangup
Selecting this option forces the MX2800 to end an established call.
Last Modem Response
This status field displays the last modem response to the MX2800.
Possible responses include OK, C
N
61200290L1-1
configured for VT 100 reports error conditions in
M
ODEM
ODE
The Unit ID value programmed in the C
portion of the S
YSTEM
Management on page 3-12)
A trap code indicating the error condition
The T
C
RAP
OMMUNITY
3-24)
The date and time when the error was logged
M
is configured for PPP or SLIP, the MX2800
ODEM
ODE
port function for your application (VT 100, PPP,
Modem
port, located on the rear panel of the MX2800,
Modem
D
, and N
O
IALTONE
O
MX2800 User Manual
M
screen (see System
ANAGEMENT
N
(see Trap Community Name on page
AME
IP A
RAP
DDRESSES
ANAGEMENT
ODEM
Modem
, B
ONNECT
C
.
ARRIER
Chapter 3. Configuration
I
IRCUIT
DENTIFICATION
(see Trap IP Addresses
P
(see
ORT
.
port (1200, 2400,
, E
,
USY
RROR
3-15
Advertisement
Table of Contents
