ADTRAN MX2800 User Manual page 58

Chapter 3. Configuration
DS3 Alarm Traps (Far-End Active Cards)
Trap
LOS
OOF
AIS
RAI
IDLE
DS3 Eqpt Fail
SA
DS3 Eqpt Fail
NSA
Comn Eqpt Fail
NSA
3-22
If enabled, the unit issues a trap when...
the remote unit's active controller card has lost
the network Rx signal.
the remote unit's active controller card detects
a framing loss from the network.
the remote unit's active controller card is re-
ceiving an AIS (blue) alarm condition from the
network.
the remote unit's active controller card is re-
ceiving an RAI (yellow) alarm from the network.
This alarm is a signal sent back toward the
source of a failed transmit circuit. The X-bits
(X1 and X2) are set to zero.
the remote unit's active controller card detects
an idle sequence from the network. Service is
immediately available for use.
the remote unit's active controller card is re-
ceiving a service-affecting equipment failure
message from the network.
the remote unit's active controller card is re-
ceiving a non-service-affecting equipment fail-
ure message from the network.
the remote unit's active controller card is re-
ceiving a common equipment failure message
from the network.
MX2800 User Manual 61200290L1-1