Table of Contents
Advertisement
loopback requests, CSU 3-9
LOS
24 Hour Alarm History (DS3 statistics) 5-3
DS3 3-16
DS3 Alarm Traps Far-end Active Cards 3-22
DS3 Alarm Traps Near-end Active and Stand-
by Cards 3-21
Remote status 4-3
State 4-2
T1/E1 Alarm Traps 3-23
T1/E1 Alarms 3-18
T1/E1 State 4-8
Loss of Signal Alarms 5-10
M
M13 and DS3 configuration 3-3
Malfunction, Power Supply Alarm 3-18
Malfunction, Power Supply Alarm Trap 3-20
management station addresses 3-25
max switches 3-19
Max Switches, Controller Trap 3-19
Maximum Redial Attempts menu 3-14
M-Bit Errors (MBE) 5-6
menu navigation 2-11
metallic diagnostic loopback 6-8
MIB II Standard Alarm Traps 3-24
Authentication Failure 3-24
Cold Start 3-24
Link Down 3-24
Link Up 3-24
MIB, SNMP 1-4
Min. Switching Period menu 3-5
Miscellaneous menu 3-25
Miscellaneous menus, network configuration 3-6
MODEM FAILURE 3-28
Modem Mode menu 3-15
modem port
description 2-8
location 2-7
pin assignments A-2
Multiple DS1 LOS
T1/E1 Alarm Traps 3-23
Multiple DS1 LOS, Remote status 4-4
61200290L1-1
MX2800 options 1-4
MX2800 overview 1-1
N
navigating the menus 2-11
network failure protection 7-1
Network Interface menus 3-3
network interface, configuring 3-3
network manager, SNMP 1-3
Network Protection menu 3-5
Network, Protection mode 4-6
None, Protection mode 4-6
non-redundant power mode 8-2
Normal
Power Supply State 4-4
Remote status 4-3
Not Installed, Card A/Card B 4-6
O
OK
DS2 State 4-7
T1/E1 state 4-8
OOF
DS2 Alarm Traps 3-23
DS2 Statistics 24 Hour Alarm History 5-7
DS3 Alarm Traps Far-end Active Cards 3-22
DS3 Alarm Traps Near-end Active and Stand-
Remote status 4-3
operating the MX2800, overview of 2-1
options for the MX2800 1-4
P
PASS 3-28
Password menu 3-24
password, setting the 3-24
Pause Between Calls menu 3-14
PBERR 5-8
P-Bit Coding Violations (PCV) 5-5
P-Bit Errored Seconds (PES) 5-5
P-Bit Severely Errored Seconds (PSES) 5-5
MX2800 User Manual
by Cards 3-21
Index
Index-5
Advertisement
Table of Contents
