Table of Contents
Advertisement
Introduction
Chapter 1
PRODUCT OVERVIEW
The MX2800 is an M13 multiplexer that consolidates T1 and E1
signals into a T3 circuit. This unit provides a cost-effective, versatile
tool for combining independent T1s, E1s, or a combination of the
two over the same T3 circuit.
The MX2800 houses two hot-swappable controller cards which
provide 1:1 redundancy for the T1 and T3 signals as well as the T3
connections.
Embedded SNMP (simple network management protocol) and
Telnet are available through the modem port using SLIP/PPP or
through the 10BaseT ethernet port. Using the Management
Information Base II (MIB II), RFC 1407 standards, and an ADTRAN
enterprise MIB, the MX2800 can be configured, monitored, and
diagnosed with standard SNMP network management programs
such as Hewlett Packard's HP OpenView™ and Cabletron's
Spectrum™.
Complete configuration, diagnostics, and performance monitoring
are available through SNMP, Telnet, or a VT 100 terminal interface.
This connection can be made via ethernet, a local EIA-232 link, or
through the built-in V.34 modem (see the note at the end of this
section on page 1-2). The modem can dial-out a "cry for help" for
units located in unmanned facilities. The MX2800 is designed for
either desktop use or for installation in a 19- or 23-inch rack.
61200290L1-1
MX2800 User Manual
1-1
Advertisement
Table of Contents
