Setting The Scan Format - Muratec MFX-2550 User Manual

4
Specify the destination, and press <Start>.
• For details on the procedure, refer to "
• If you loaded the document in the ADF, this concludes the procedure.
• If you loaded the document on the document glass, load the next document, and press
[Next Doc]. To finish scanning, press [Complete].

Setting the Scan Format

You can set whether to scan the document in color or monochrome.
1
Load the document, and press <Scan>.
For details on loading documents, refer to Chapter 1, "Loading Documents" in the User's
Guide.
2
Press [Color].
• Scan format switches between "Mono" and "Color" each time you press [Color].
• If [Color] is not displayed, press [Advanced] and then select [Color].
3
Specify the destination, and press <Start>.
• For details on the procedure, refer to "
• If you loaded the document in the ADF, this concludes the procedure.
• If you loaded the document on the document glass, load the next document, and press
[Next Doc]. To finish scanning, press [Complete].
1-24 Basic Scan Settings
Basic Scanning". (See page 1-2.)
Basic Scanning". (See page 1-2.)