Change 80211 Network Mode - Lantronix MSS Reference Manual

Change 80211
Restrictions
Errors
Parameters
Defaults
Examples
See Also

2.2.7 Change 80211 Network Mode

CHANGE 80211 NETWORKMODE
Denotes whether the MSS operates in a peer-to-peer (AdHoc) or managed (Infrastructure) network
environment.
Any configuration changes you make will not take place until you issue the Change 80211 Reset command.
Restrictions
Errors
Parameters
Defaults
Examples
See Also
2-6
Requires privileged user status.
Only applies to the MSS-VIA and certain MSS4 models.
If you enter a command that is not applicable to the 802.11 card currently in
use, you will receive an Error message.
Card
Instructs the MSS to use the MAC address of the wireless PC card that is
inserted into one of its PC card slots.
MSS
Instructs the MSS to use its own internal MAC address.
MSS
Local>> CHANGE 80211 MACADDRESS CARD
Local>> CHANGE 80211 RESET
Show 80211, page 2-63
ADHOC
INFRASTRUCTURE
Requires privileged user status.
Only applies to the MSS-VIA and certain MSS4 models.
If you enter a command that is not applicable to the 802.11 card currently in
use, you will receive an Error message.
AdHoc
Specifies that the MSS is communicating with other wireless devices in a peer-
to-peer capacity.
Infrastructure
Specifies that the MSS is communicating with an Access Point (AP).
Infrastructure
Local>> CHANGE 80211 NETWORKMODE ADHOC
Local>> CHANGE 80211 RESET
Show 80211, page 2-63
Command Reference