Change Loginpass; Change Modem Control - Lantronix MSS Reference Manual

Command Reference

2.31 Change Loginpass

CHANGE SERVER LOGINPASS passwd
Specifies the password used to log into the MSS. The password should consist of no more than 6 alphabetic
letters. Users are only required to provide this password if the port has Password Protect enabled.
If you do not enter the password at the command line, you will immediately be prompted to enter the new
password. This password is not displayed when typed.
Restrictions
Parameters
Defaults
Examples
See Also

2.32 Change Modem Control

CHANGE PORT PortList MODEM CONTROL
Causes the MSS to treat any attached serial device as a modem. When enabled, a DSR drop will log out the
enabled port and the MSS will drop DTR for three seconds and then raise it when the port logs out. If
Autostart is also enabled, the port will not start until DSR is raised. The MSS supports partial modem control
(DSR/DTR).
Restrictions
Errors
Parameters
In the absence of the PortList parameter, the configuration will affect the MSS4's
Note:
current port only.
Requires privileged user status.
Server
MSS4 only.
passwd
Enter a password of up to 6 alphabetic characters. When entered as part of the
command, the password should be enclosed by quotation marks to preserve
case.
access
CHANGE LOGINPASS "badger"
Change Password Protect, page 2-38; Change Incoming, page 2-26.
DISABLED
ENABLED
Requires privileged user status.
Does not apply to the MSS485.
Modem Control must be disabled to use DSRLogout.
Port
MSS4 only. Specifies a particular port or group of ports.
Change Loginpass
2-31